MS3 - Digital CAN-BUS wideband input
#1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I've finally got around to installing the MS3 that Dimitris @ MSLabs built for my daily - it's got one of his full-fat MS3's including the digital wideband to CAN converter.
Combined with the Innovate LC-2 it's genuinely spot on.
With some of the more expensive stuff I tune they run pretty impressive wideband strategy's with different trim PID controls for high & low load etc - meaning that on EVERY car I run closed loop fuel all the time [correctly tuned of course] but I've never felt that the analog input and MS combo was strong enough for this to work.
Until now.
The response is rapid and solid, and due to Dimitris awesome code writing the MS will stop the CL trims should the sensor die etc. there's no ground level to worry about and makes the install/tune stress free.
Go buy one.
Be happy.
Combined with the Innovate LC-2 it's genuinely spot on.
With some of the more expensive stuff I tune they run pretty impressive wideband strategy's with different trim PID controls for high & low load etc - meaning that on EVERY car I run closed loop fuel all the time [correctly tuned of course] but I've never felt that the analog input and MS combo was strong enough for this to work.
Until now.
The response is rapid and solid, and due to Dimitris awesome code writing the MS will stop the CL trims should the sensor die etc. there's no ground level to worry about and makes the install/tune stress free.
Go buy one.
Be happy.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM