MS1 No Spark 1 and 4
#1
Thread Starter
Junior Member
iTrader: (1)
Joined: Dec 2013
Posts: 154
Total Cats: 0
From: Ontario, Canada
MS1 No Spark 1 and 4
Hey,
All of the sudden my car runs really bad, i am not getting spark for cylinders 1 and 4. It barely starts and runs around 3-400rpm, for about 20 seconds of running only the 2 and 3 exhaust manifold pipes get warm and 1 and 4 stay cold. Pull the plugs 1 and 4 are wet with raw fuel, 2 and 3 are dry and covered in carbon. I have tried a different cam angle sensor, plugs, and stock coil packs and plug wires as i have toyota cops on there normally. Car drove fine to work sunday night, come out in the morning and it barely starts and runs like pewp.
Its a MS1 PNP, is there anything on the ecu i can check that sends the spark signal? Any other ideas?
Thanks in advance!
All of the sudden my car runs really bad, i am not getting spark for cylinders 1 and 4. It barely starts and runs around 3-400rpm, for about 20 seconds of running only the 2 and 3 exhaust manifold pipes get warm and 1 and 4 stay cold. Pull the plugs 1 and 4 are wet with raw fuel, 2 and 3 are dry and covered in carbon. I have tried a different cam angle sensor, plugs, and stock coil packs and plug wires as i have toyota cops on there normally. Car drove fine to work sunday night, come out in the morning and it barely starts and runs like pewp.
Its a MS1 PNP, is there anything on the ecu i can check that sends the spark signal? Any other ideas?
Thanks in advance!
#4
Thread Starter
Junior Member
iTrader: (1)
Joined: Dec 2013
Posts: 154
Total Cats: 0
From: Ontario, Canada
I think it may be MS related; for mine on the main board D14 LED is spark output A and D16 LED is spark output B. With power to the ecu only D14 LED is on and it has like 1.7 volts, i know before i have seen both of these light up with power to the ecu. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post