MegaSquirtPNP2 and AEM Wideband X series
#1
MegaSquirtPNP2 and AEM Wideband X series
Hey guys, I'm in the middle of pulling out an innovate SG1 and going to an AEM 30-0300 X-Series Wideband. I believe I have it wired in properly but my AFR in tuner studio does not move much. It's pegged in the red at 18+ and moves very little. I have tried changing the AFR controller settings in TS but it did not seem to help. Here is the set up so far. Any help would be appreciated.
Car is a 99 NB1 with an MSPNP2
Red from the Wideband is a fused 12v from the battery
Black from the Wideband is pinned to #5 Chassis ground
White from the Wideband is pinned to #21 Oxygen Sensor
Car is a 99 NB1 with an MSPNP2
Red from the Wideband is a fused 12v from the battery
Black from the Wideband is pinned to #5 Chassis ground
White from the Wideband is pinned to #21 Oxygen Sensor
#4
Did you ever get it going
I’m curious if you ever got the arm gauge to work with mspnp2
Hey guys, I'm in the middle of pulling out an innovate SG1 and going to an AEM 30-0300 X-Series Wideband. I believe I have it wired in properly but my AFR in tuner studio does not move much. It's pegged in the red at 18+ and moves very little. I have tried changing the AFR controller settings in TS but it did not seem to help. Here is the set up so far. Any help would be appreciated.
Car is a 99 NB1 with an MSPNP2
Red from the Wideband is a fused 12v from the battery
Black from the Wideband is pinned to #5 Chassis ground
White from the Wideband is pinned to #21 Oxygen Sensor
Car is a 99 NB1 with an MSPNP2
Red from the Wideband is a fused 12v from the battery
Black from the Wideband is pinned to #5 Chassis ground
White from the Wideband is pinned to #21 Oxygen Sensor
Thread
Thread Starter
Forum
Replies
Last Post