Injector resistor pack
#21
Elite Member
Thread Starter
iTrader: (24)
Join Date: Jun 2007
Location: Woodland Hills, CA
Posts: 4,667
Total Cats: 18
well, i got that. but do i need to change any seetings in megasquirt to make sure it knows that im running low impedance injectors?
i can always try speaking to it but i dont think it will help :/
i can always try speaking to it but i dont think it will help :/
#22
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,456
Total Cats: 6,874
The exact settings will differ for different injectors, but here's the writeup on tuning them: http://www.megamanual.com/v22manual/mtune.htm#pwm
#26
so basically, running MS pnp with low-imp injectors...
You utilize MS PWM to configure the injectors to run as low-imp
and quoted from joe perez...
"run a pair of heavy (16 ga or so) wires directly from the ground side of R37/R38 to a dedicated ground."
after you run the 16 ga wire w/configuring MS PWM you should be set on running low-imp injectors?
Just wondering if I left a step out
Thanx a bunch joe, you knowledge is much appreciated
You utilize MS PWM to configure the injectors to run as low-imp
and quoted from joe perez...
"run a pair of heavy (16 ga or so) wires directly from the ground side of R37/R38 to a dedicated ground."
after you run the 16 ga wire w/configuring MS PWM you should be set on running low-imp injectors?
Just wondering if I left a step out
Thanx a bunch joe, you knowledge is much appreciated
Last edited by malachi_fox; 04-28-2009 at 04:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post