long story short. i was configuring my ms diy to an na8 and i lifted the soldering pad on the main board for the tps signal. preferably i would not like to buy another board. is there another place on the main board i can solder the jumper for the tps? i have tried to follow the trace to see where the pad originates in hopes i can just jump that to the connector board but no luck so far. some help will be greatly appreciated!!! ooops

 

Email diyautotune.

Or grab a multimeter and follow where the signal goes.

 

Turn the white microsquirt board upside down. There's a legend with the pins/functions, look for TPS.

 

thanks for the tip reverant! tps is pin13. i followed the trace from the tps on microsquirt to the lifted pad on the mainboard. now can i just jump pin13 from the underside of my mainboard to the connector board? when i followed the trace there wasn't any other electrical components that belonged with that trace.