Diypnp firmware issues
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Oct 2013
Location: Arcade, New York
Posts: 157
Total Cats: -1
Diypnp firmware issues
I just completed building a diypnp setup and have been trying for the last 5hrs on how to load the firmware. I followed the instructions and I get the diypnp unit to except the current version of the appropriate firmware in the ms2loader it says it goes 100%.
I then try it in the tuner studio lite version and it identifies the diypnp unit but it shows a box saying this error. I have tried reloading the firmware half dozen times and still the same results. Anyone that can help me I would appreciate it, I was hoping on trying to start my car tomorrow but it looks grim.
Thanks, Bill
I then try it in the tuner studio lite version and it identifies the diypnp unit but it shows a box saying this error. I have tried reloading the firmware half dozen times and still the same results. Anyone that can help me I would appreciate it, I was hoping on trying to start my car tomorrow but it looks grim.
Thanks, Bill
#2
I won't claim to know exact cause of your issue but thought i'd chuch the DIYAutotune guide link up in case you're working to something else. I did mine fine following this:
DIYPNP Firmware Loading Walkthrough - DIYAutoTune.com
Did you have the Boot Jumper installed?
Dave
DIYPNP Firmware Loading Walkthrough - DIYAutoTune.com
Did you have the Boot Jumper installed?
Dave
#3
Junior Member
Thread Starter
iTrader: (2)
Join Date: Oct 2013
Location: Arcade, New York
Posts: 157
Total Cats: -1
That's the guide I followed. The link they give for the firmware is the link I clicked and loaded my firmware from. I also have the boot jumper in place. I am frustrated. The usb serial adapter I bought along with the diypnp would not install on my laptop. I had to install it on my wife's laptop and now this damn firmware shows me it's loaded 100% in the ms2loader.
As soon as I get it in the tuner studio and start a new project. It reads it it knows its there but tells me no firmware!! I dunno, thanks Dave for trying.
As soon as I get it in the tuner studio and start a new project. It reads it it knows its there but tells me no firmware!! I dunno, thanks Dave for trying.
#7
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,729
Total Cats: 4,126
loading firmware couldn't be easier.
where are you failing? because if you see "verification sucessful" after watching the firmware load for about 2 minutes, then you shouldn't be seeing "no firmware loaded" once you connect to TS.
where are you failing? because if you see "verification sucessful" after watching the firmware load for about 2 minutes, then you shouldn't be seeing "no firmware loaded" once you connect to TS.
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM