Cranking and ASE tuning
#21
Thread Starter
Senior Member
iTrader: (14)
Joined: Oct 2006
Posts: 677
Total Cats: 6
From: South East Florida
I changed from Rising to Falling Edge. Same result with 31 and 32 errors.
Did I throw off the timing completely turning the engine over by hand when I removed this pulley (piece of my old supercharger)????
after removal
#32
Thread Starter
Senior Member
iTrader: (14)
Joined: Oct 2006
Posts: 677
Total Cats: 6
From: South East Florida
It is making sense now. The pin is there as a guide to make sure the timing marks are in the right spot.
This should be relatively easy: take off the accessory belts, line up the pulley and bolt down.
The arp bolts are $20 from FM. Ordering this morning.
#37
Thread Starter
Senior Member
iTrader: (14)
Joined: Oct 2006
Posts: 677
Total Cats: 6
From: South East Florida
Today it started, but ran poor. Seemed down on cylinders or timing way off.
It was goofy: went back to rising, logged a rough non start, flipped to falling and it showed encouragement and started with a cracked throttle.
I'll post up some more details in a few minutes.
It was goofy: went back to rising, logged a rough non start, flipped to falling and it showed encouragement and started with a cracked throttle.
I'll post up some more details in a few minutes.
#38
Thread Starter
Senior Member
iTrader: (14)
Joined: Oct 2006
Posts: 677
Total Cats: 6
From: South East Florida
This is the log of it 'running.' Falling edge.
I do notice sync 32 is gone, and secL resets and at times holds constant. I don't recall the significance of the secL, read something about it a few weeks ago.
Guess I did not line up things correctly? Pictures to follow.
I do notice sync 32 is gone, and secL resets and at times holds constant. I don't recall the significance of the secL, read something about it a few weeks ago.
Guess I did not line up things correctly? Pictures to follow.
#39
Thread Starter
Senior Member
iTrader: (14)
Joined: Oct 2006
Posts: 677
Total Cats: 6
From: South East Florida
The trigger wheel and the pulley seemed to only line up a single way. Please check me here.
The hole, where I assume the pin used to be, is difficult to see in the pictures. It is on the left in the 270degree position. I lined up the holes.
I did not run the belt to the power steering or the AC as I realized I am missing the tensioner. It must have been taken off when the supercharger was installed.
Is this the sensor for the trigger wheel? It was covered in sludge from the AC leaking.
The hole, where I assume the pin used to be, is difficult to see in the pictures. It is on the left in the 270degree position. I lined up the holes.
I did not run the belt to the power steering or the AC as I realized I am missing the tensioner. It must have been taken off when the supercharger was installed.
Is this the sensor for the trigger wheel? It was covered in sludge from the AC leaking.