Communication port fail
#1
Thread Starter
Senior Member
iTrader: (3)
Joined: Oct 2008
Posts: 610
Total Cats: 12
From: Indianapolis
Communication port fail
I finally got my car done. Followed Reverands instructions but my computer wont connect to the megasquirt.
I downloaded the FTDI drivers, version 2.12.12.0 on my Windows 10 laptop. I verified that it is connecting to the laptop under device manager. Its COM3 @ 115200 bits/second. Every time I try to connect to tuner studio, tuner studio says connection failed. If I try to "detect port" it doesn't detect anything.
The car actually starts and idles fine.
What do I do?
I downloaded the FTDI drivers, version 2.12.12.0 on my Windows 10 laptop. I verified that it is connecting to the laptop under device manager. Its COM3 @ 115200 bits/second. Every time I try to connect to tuner studio, tuner studio says connection failed. If I try to "detect port" it doesn't detect anything.
The car actually starts and idles fine.
What do I do?
#2
Thread Starter
Senior Member
iTrader: (3)
Joined: Oct 2008
Posts: 610
Total Cats: 12
From: Indianapolis
Well, I restarted tuner studio and the problem fixed itself.
Now I need to figure out why the tachometer doesn't work and why the fuel pump runs non stop instead of just priming the line for 2 seconds when you turn the ignition on.
Now I need to figure out why the tachometer doesn't work and why the fuel pump runs non stop instead of just priming the line for 2 seconds when you turn the ignition on.
Thread
Thread Starter
Forum
Replies
Last Post