Can't set base timing
#1
Can't set base timing
I just installed and built MS following the directions on DIY's site. I'm using a fixed angle on 10 degrees in megatune, but the timing mark is 90 degrees retarded. Is it possible that when I did my timing belt, I installed the pulley 90 degrees off? The car starts runs and drives fine. I haven't messed with or even checked the ignition timing after the timing belt.
Thanks
-Rouphis
Thanks
-Rouphis
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM