Hello again
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Aug 2009
Location: Chaparral, New Mexico
Posts: 200
Total Cats: 9
Hello again
Haven't had a Miata for a few years, just picked this one up in central Texas a few days ago. I will be starting a thread on some questions I have. Does anyone recognize this car though from a past member? Just curious what else may have been done to it. From my understanding it was given in a trade and then sold off after sitting for a while. For instance curious to see if it has an aftermarket clutch and thus a stiff pedal or is the throughout bearing no good.
-JR m45
-RB front and rear sways with front sway reinforcing bar
-RB header and full exhaust
-KYB AGX shocks and maybe H&R springs
-HardDog M2 hard top roll bar I believe, need to measure it.
-Air to water intercooler
-Either custom or old snow performance boost cooler kit plumbed from windshield reservoir
-JR BTC and power card
-JR m45
-RB front and rear sways with front sway reinforcing bar
-RB header and full exhaust
-KYB AGX shocks and maybe H&R springs
-HardDog M2 hard top roll bar I believe, need to measure it.
-Air to water intercooler
-Either custom or old snow performance boost cooler kit plumbed from windshield reservoir
-JR BTC and power card
#3
Junior Member
Thread Starter
iTrader: (2)
Join Date: Aug 2009
Location: Chaparral, New Mexico
Posts: 200
Total Cats: 9
First thing on the list to buy is a wideband, should be able to retard the timing to at least a safe spot until I can get MS. Probably get a new methanol injection kit, pre and post blower and get rid of the air to water intercooler. Then up the boost a bit and should be potent enough until I decide to k or ls swap it.
#5
Junior Member
Thread Starter
iTrader: (2)
Join Date: Aug 2009
Location: Chaparral, New Mexico
Posts: 200
Total Cats: 9
I was thinking the same thing, not sure if I should get MS2 or 3 though, wither way resale is super easy here if it cane to selling it for a swap. Getting the car sorted as is with methanol injection and a new pulley to up the boost a bit and tuned with MS would also leave it in a decent place to swap the supercharger for a turbo in the future.
#6
I'll let the pros guide you on that but I have a MS3Pro sitting in my garage waiting to be installed on my car. I do know that engine swap stuff can get rather expensive really quick. I started adding up what it would cost to do a K-swap in my 1992 to my liking and decided it was a better investment of my time and money to just buy a s2k. I now have both and don't regret the decision at all. I know there is a market for it and I still would really love to do it, I just didn't feel like throwing $10k+ in the firepit. Either way, good luck on whatever direction you decide to go.
Thread
Thread Starter
Forum
Replies
Last Post