forced induction is old news.
#21
Boost Czar
![](/mt2011/images_td/ranks/supporter1.gif)
![](/mt2011/images_td/ranks/admin.png)
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,688
Total Cats: 4,113
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Note: When using the Bosch Sensors the LC-1 may perform multiple calibration passes.
This is normal and need not cause concern. When it completes, the LC-1 also will perform
a free air calibration. Make sure the sensor is operating in free air for the heater and free
air calibration.
This is normal and need not cause concern. When it completes, the LC-1 also will perform
a free air calibration. Make sure the sensor is operating in free air for the heater and free
air calibration.
#22
2 Props,3 Dildos,& 1 Cat
![](/mt2011/images_td/ranks/supporter1.gif)
![](/mt2011/images_td/ranks/smod.png)
Thread Starter
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
so I think it's working again. my calibration may be questionable but that's ok for now.
I believe my issue is that the terminator and serial connection are weak pieces of crap. I re-seated them a few times and checked all the connections and now it seems to be ok.
incidentally, Innovate is dumb because they ignore the onboard calibration resistor value.
I believe my issue is that the terminator and serial connection are weak pieces of crap. I re-seated them a few times and checked all the connections and now it seems to be ok.
incidentally, Innovate is dumb because they ignore the onboard calibration resistor value.
Thread
Thread Starter
Forum
Replies
Last Post
mikeflys1
Miata parts for sale/trade
15
10-27-2018 02:19 PM