Aw Fuckin' A
#1
Thread Starter
Boost Czar
iTrader: (62)
Joined: May 2005
Posts: 79,818
Total Cats: 4,152
From: Chantilly, VA
Aw ******' A
it wasnt just my sensor that crapped out, the LC-1 is not working properly....
no sensor plugged in and get "voltage too low error 9"
plugged matt's sensor in and get "heater circuit open error 2"
same thing on my sensor....
retraced the wiring, nothing has changed, just crapped out on me.
So, tomorrow is the dyno and now I gotta rely on the crap "sniffer" for a wbo2 plot....oh well, it's tuned close where i dont need one, but I was in the middle of fine tuning cruise when it died, I'll propably have crap for fuel mileage on the way....
that DIY WB guy is looking a lot better to me right now.
no sensor plugged in and get "voltage too low error 9"
plugged matt's sensor in and get "heater circuit open error 2"
same thing on my sensor....
retraced the wiring, nothing has changed, just crapped out on me.
So, tomorrow is the dyno and now I gotta rely on the crap "sniffer" for a wbo2 plot....oh well, it's tuned close where i dont need one, but I was in the middle of fine tuning cruise when it died, I'll propably have crap for fuel mileage on the way....
that DIY WB guy is looking a lot better to me right now.
#8
Thread Starter
Boost Czar
iTrader: (62)
Joined: May 2005
Posts: 79,818
Total Cats: 4,152
From: Chantilly, VA
Yeah, actually PMed Jerry from DIY since I bought it through them...ill play with it later and try again, but then I'll get in touch with Philippe at Innovative.
I might rip it out completely and try to temporarily rewire it, as I routed it all donkey. But it was wokring and then not, and another sensor throws the same errors, so i dont have my hopes set too high.
I might rip it out completely and try to temporarily rewire it, as I routed it all donkey. But it was wokring and then not, and another sensor throws the same errors, so i dont have my hopes set too high.
#10
Thread Starter
Boost Czar
iTrader: (62)
Joined: May 2005
Posts: 79,818
Total Cats: 4,152
From: Chantilly, VA
I could at least try to wire it up and see if i get the same error, but i doubt I'll get around to it tomorrow during the course of the day...its only a few wires, but i really dont know if wanna bother crawling under the car and pulling ****..we'll see....
ill be fine on the dyno without one, just sucks that i wont be able to capture my logs with the wbo2 reading...and i really cant tune anything, so im stuck with my map as is....but i do need a fix sometime soon...if its not one thing it's always another.
ill be fine on the dyno without one, just sucks that i wont be able to capture my logs with the wbo2 reading...and i really cant tune anything, so im stuck with my map as is....but i do need a fix sometime soon...if its not one thing it's always another.
Thread
Thread Starter
Forum
Replies
Last Post
Quality Control Bot
Insert BS here
27
10-06-2011 10:41 AM