ABS light
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2009
Location: Atlanta,GA
Posts: 162
Total Cats: 0
ABS light
ugh
just removed my roll bar
the previous owner had it welded in not even correctly
had to sawzall FTL!! probably won't be able to put another one again ever
i still have mounting plates in rear and stubs coming up about 3 inches
anyway reservoir is full, harnesses are all connected
never had an ABS light until the moment i cranked the car after roll bar removal
any pics of what i should check, anyone have this before??
**** MY LIFE RIGHT NOW
just removed my roll bar
the previous owner had it welded in not even correctly
had to sawzall FTL!! probably won't be able to put another one again ever
i still have mounting plates in rear and stubs coming up about 3 inches
anyway reservoir is full, harnesses are all connected
never had an ABS light until the moment i cranked the car after roll bar removal
any pics of what i should check, anyone have this before??
**** MY LIFE RIGHT NOW
#2
You probably have sawzalled/disconnected one of the signal cables, going to the rear hubs. The signal cables for the rear run through the right door sill. The right one goes straight through the tunnel next to the gas tank, while the other one runs in front of the gas tank, under the metal cover.
Try pulling both wires at the rear wheels. If one happens to be loose or pull through, that's your problem.
EDIT: also check your fuse
Try pulling both wires at the rear wheels. If one happens to be loose or pull through, that's your problem.
EDIT: also check your fuse
Last edited by Cococarbine3; 12-22-2009 at 11:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post