Re-sizing and printing Hydra maps
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: May 2007
Location: Austin, TX
Posts: 1,881
Total Cats: 2
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Is there anything in the software to allow me to resize my maps to fit it all on one screen for viewing and printing?
And once I get it to all fit on a single screen is the only way to print it by using a screen capture?
This may seem dumb, but how do I add cells to the map for increased boost and additional rpms? I'm sure this is simple and I just am overlooking it.
And once I get it to all fit on a single screen is the only way to print it by using a screen capture?
This may seem dumb, but how do I add cells to the map for increased boost and additional rpms? I'm sure this is simple and I just am overlooking it.
#2
2 Props,3 Dildos,& 1 Cat
![](/mt2011/images_td/ranks/supporter1.gif)
![](/mt2011/images_td/ranks/smod.png)
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
pretty sure there's no way to get them out of the software for viewing/printing. at least not in the pre-2.6 versions. screen cap and stitch seems like the way to go.
you can't add cells, but you can change their spacing. pre-2.6 it's under the settings menu for "grid x" and "grid y".
you can't add cells, but you can change their spacing. pre-2.6 it's under the settings menu for "grid x" and "grid y".
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM