What does your Qmax coolant setup look like?
11-17-2019, 05:28 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 87
Total Cats: -5
What does your Qmax coolant setup look like?
Kinda wondering if anyone has a turbo setup with the Qmax reroute or similar with coolant going to the turbo, throttle body AND heater core (plus 2 temp sensors). Where do you pull water from? and did you add any other mods to make it work? Does anyone run water return lines to anything other than straight to the water pump? I kinda wanna ditch the whole water neck on the front but that's not going to make it easier 
It may be obvious to most, but here's a link https://supermiata.com/supermiata-qm...mx5-miata.aspx
I'm not really at that stage right now but just wondering if anyone would like to share their setup or what they would do
Inn my case this will be on a 1.8 NB2
It may be obvious to most, but here's a link https://supermiata.com/supermiata-qm...mx5-miata.aspx
I'm not really at that stage right now but just wondering if anyone would like to share their setup or what they would do
Inn my case this will be on a 1.8 NB2
Reply
0
0
11-19-2019, 12:49 PM
#3
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 87
Total Cats: -5
That actually doesn't sound so stupid both of those don't really need a decent flow. The mixing manifold is the piece connected to the inlet of the water pump right? Mine came with the tb return thing ripped off. Anyway,, does the throttle body feed come from the back on your build?
both of those don't really need a decent flow. The mixing manifold is the piece connected to the inlet of the water pump right? Mine came with the tb return thing ripped off. Anyway,, does the throttle body feed come from the back on your build?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Faeflora
General Miata Chat
27
12-18-2010 02:34 PM
