Oil feed/return
#6
Welcome to the forum. https://www.miataturbo.net/meet-greet-40/
It won't work because the return would be under the same pressure as the feed, there will be no flow. You have to tap the pan.
That and you wouldn't want unfiltered oil being shoved into your nice shiny turbo right?
Follow the how to, or if you have the motor out already, take it to a welder and buy him a beer.
It won't work because the return would be under the same pressure as the feed, there will be no flow. You have to tap the pan.
That and you wouldn't want unfiltered oil being shoved into your nice shiny turbo right?
Follow the how to, or if you have the motor out already, take it to a welder and buy him a beer.
#10
Elite Member
iTrader: (9)
Join Date: Jun 2006
Location: Chesterfield, NJ
Posts: 6,922
Total Cats: 402
Put the turbo in series in the oil circuit. It will work fine.
If the turbo is watercooled, placing it in line with the radiator outlet is ideal, as the entire coolant flow will go thru it.
If the turbo is watercooled, placing it in line with the radiator outlet is ideal, as the entire coolant flow will go thru it.
#11
Slowest Progress Ever
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,028
Total Cats: 304
You don't. You drive the car onto ramps, or jack the front of the car up. You drill the pan without ever moving the engine. Just make sure you follow the instructions with the oil draining/ grease on the tap/ flushing the possible shavings/ air regulator to your breather port.
Seriously though, if you can't do this simple task, you shouldn't be putting a turbo setup on your car at all.
Seriously though, if you can't do this simple task, you shouldn't be putting a turbo setup on your car at all.
#15
Is this real life?
Read for 3 weeks, and plan a turbo kit on paper. Understand that if you want something bad enough, that you're going to have to do some things that may be inconvenient....
As mentioned before, installing an oil return line is the least of your worries if you want to turbo your car. If you can't do that, just get a MSM and be done
Read for 3 weeks, and plan a turbo kit on paper. Understand that if you want something bad enough, that you're going to have to do some things that may be inconvenient....
As mentioned before, installing an oil return line is the least of your worries if you want to turbo your car. If you can't do that, just get a MSM and be done
#20
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,339
Total Cats: 6,793
A sandwich plate can be used as an oil supply to the turbo. The ports typically provided on these plates (eg: for temp / pressure sensors) are located on the inlet side to the filter, so you'll have unfiltered oil going into your turbo. Opinions on this vary from "It'll be fine" to "The turbo will be immediately destroyed and you will die of ***-cancer."
The sandwich plate cannot be used as a return. This is because you'd then have equal pressure on both sides of the turbo, and thus, no flow. (You'd also blow the oil seals on the turbo, by exposing both its inlet and outlet ports to system pressure.) The oil return from the turbo must go to a location whose pressure is significantly less than system pressure, ideally atmospheric. The most common location is a fitting on the side of the oil pan.
You need not weld to install this fitting. The vast majority of us just drill and tap the pan to something like 3/8" NPT while it's still in the car, and use a threaded fitting with perhaps some JB-weld as a thread sealant.