Monsterflow filter, IAT sensor relocation to OEM crossover tube
07-09-2007 | 01:42 PM
#1
Thread Starter
Newb
Joined: May 2007
Posts: 3
Total Cats: 0
Monsterflow filter, IAT sensor relocation to OEM crossover tube
Picked up a very lightly used Monsterflow(MF) filter(with cleaner and tackifier) and want to attach it to the stock MAF on my N/A 99 NB.
Using the rubber gasket from the OEM airbox allows the MF to clamp and mate fine with the MAF
Now, what to do with the IAT sensor.
The NB crossover tube has a potential cutout next to the PCV tube inlet.
...Remove the crossover tube from car, drill 9/16 hole, silicone the IAT to the crossover.
Can this cutout/knockout be used to insert the IAT?
Looks like what is was designed for.
Any flow issues with the IAT being closer to the throttlebody?
Thanks, woodchuk
Using the rubber gasket from the OEM airbox allows the MF to clamp and mate fine with the MAF
Now, what to do with the IAT sensor.
The NB crossover tube has a potential cutout next to the PCV tube inlet.
...Remove the crossover tube from car, drill 9/16 hole, silicone the IAT to the crossover.
Can this cutout/knockout be used to insert the IAT?
Looks like what is was designed for.
Any flow issues with the IAT being closer to the throttlebody?
Thanks, woodchuk
Last edited by woodchuk; 07-09-2007 at 03:06 PM. Reason: add picture
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
