Modifying Narrowband output for LC1
#1
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jul 2006
Location: Central California
Posts: 2,557
Total Cats: 5
Modifying Narrowband output for LC1
I got my LC1 installed finally after sitting on the shelf for a few months, and spent some time tuning my AFPR. Then it occurred to me that I have the ability to modify the narrowband sensor output to tell the ecu whatever I want it to (I.e tell the computer it is running more lean or rich than what is actually happening). So I started to mess around with the settings a bit before it got dark. A typical narrowband sensor outputs 1v@14:1 and 0v@15:1, however I have my ecu seeing 1v@13.0 and 0v@14.5
The result was less lean tip in and quicker spool time, along with running a bit richer at idle, but i could care less about running rich right now as I just wanna be faster for the autocross tomorrow. Also I ended up tuning the AFPR to run 55-57 psi at idle and the rise adjuster is screwed most of the way in. Air fuel ratios in boost are about 12:1 which is a bit rich for 5 psi, but safe i think.
The result was less lean tip in and quicker spool time, along with running a bit richer at idle, but i could care less about running rich right now as I just wanna be faster for the autocross tomorrow. Also I ended up tuning the AFPR to run 55-57 psi at idle and the rise adjuster is screwed most of the way in. Air fuel ratios in boost are about 12:1 which is a bit rich for 5 psi, but safe i think.
#3
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jul 2006
Location: Central California
Posts: 2,557
Total Cats: 5
Ok i autocrossed the car today (sat. March 10) and it worked so so much better than last time. Power was much more predictable and there was no major bogging. Gas mileage went down quite a bit though as expected.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM