How do I route wires through dash to a pillar?
#1
How do I route wires through dash to a pillar?
Setting up AEM wideband right now. I have the replacement a pillar that the gauges go in but I need to route the wires from the footwell area to the a pillar. I can't see any way to route the wires up to the a pillar, there's just no passage. I even stuck a borescope down the base of the pillar and couldn't find a way through. How did you guys do it? Is there something I'm missing here?
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,339
Total Cats: 6,793
Assuming you have a 1992 Miata (as you haven't specified otherwise), there's no pleasant way to do this. You just need to straighten out a coat hanger, remove the plastic trim from the A-pillar, and start probing downwards with the coat hanger until you make it through.
Disconnect the battery negative terminal first, if you're a wimp.
Disconnect the battery negative terminal first, if you're a wimp.
Thread
Thread Starter
Forum
Replies
Last Post
catlin987987
DIY Turbo Discussion
22
02-13-2012 01:12 AM
viriiguy
General Miata Chat
20
05-11-2011 06:42 AM