DIY PNP not working at all
#1
DIY PNP not working at all
So I picked up a diy pnp used and it was set up for a 1993 my cars a 97 so I followed the turbo kitty wiring for the pnp jumper board but was unable too get 12v at that point
rechecked wiring and the car more matched up with the 93 wiring but even then things still don’t line up with some pins allocated actually matching up with 97 wiring
in my set here are my issues
- techno error conflict with settings
- only got spark on 1&2 in test mode
4 sets off my fan and my fuel injection relay clicks like mad the fan stays on when exiting test mode
- I do get a rpm signal in tuner studio but no tach output
- fuel pump doesn’t prime
I made my own pin out off my harness well colour code my cables
I have no idea what I’m doing I’ve done a turbo install now I’m completely stuck as electricals arnt my forte
below is my pin out
rechecked wiring and the car more matched up with the 93 wiring but even then things still don’t line up with some pins allocated actually matching up with 97 wiring
in my set here are my issues
- techno error conflict with settings
- only got spark on 1&2 in test mode
4 sets off my fan and my fuel injection relay clicks like mad the fan stays on when exiting test mode
- I do get a rpm signal in tuner studio but no tach output
- fuel pump doesn’t prime
I made my own pin out off my harness well colour code my cables
I have no idea what I’m doing I’ve done a turbo install now I’m completely stuck as electricals arnt my forte
below is my pin out
Thread
Thread Starter
Forum
Replies
Last Post