Bye, Bye, MAF
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: Athens, GA
Posts: 247
Total Cats: 0
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Finally removed the mass air flow sensor (thanks to the megasquirt). Here is my Lowe's special intake, a temporary set up until I go turbo. I've laid the radiator back in hopes of running my intercooler pipes over the radiator. The cover panel was my first attempt, I cut it out of some scrap fiberglass RV siding that I picked up at my parent's store. I'll make a cleaner one once the turbo is in.
![](http://bfhgarage.com/BFH-Images/miata/enginebay93007.jpg)
![](http://bfhgarage.com/BFH-Images/miata/coldair.jpg)
Mmmm... PVC and brass plumbing fittings
![](http://bfhgarage.com/BFH-Images/miata/idleair.jpg)
The GM air temp sensor
![](http://bfhgarage.com/BFH-Images/miata/tempsensorlocation.jpg)
The filter as seen through the front grill
![](http://bfhgarage.com/BFH-Images/miata/filter.jpg)
The car runs, but it is running rich. I'll be working on that issue this week...
![](http://bfhgarage.com/BFH-Images/miata/enginebay93007.jpg)
![](http://bfhgarage.com/BFH-Images/miata/coldair.jpg)
Mmmm... PVC and brass plumbing fittings
![](http://bfhgarage.com/BFH-Images/miata/idleair.jpg)
The GM air temp sensor
![](http://bfhgarage.com/BFH-Images/miata/tempsensorlocation.jpg)
The filter as seen through the front grill
![](http://bfhgarage.com/BFH-Images/miata/filter.jpg)
The car runs, but it is running rich. I'll be working on that issue this week...
#2
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
anyone think the IAT sensor sitting right near the radiator is gonna get heat soaked and throw off the the air temps? I was a lil concerned about mine and it's much further away and off to the passenger side of the tb
Thread
Thread Starter
Forum
Replies
Last Post