When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
so it seems as though the boundary pump is consistantly showing lower hot idle oil pressure than stock. Mine is 10-12 as read with a bosch gauge. that is with 10w40.
I've emailed Savington asking about it, it seems a bunch of us are having similar results with the boundary pump. 10-12 with 10w-40 seems to be consistent with me having 8-10 with 10w-30. It's curious that you guys haven't had any engine issues, how many miles have you driven with the pump?
- I've been on the BE since mid 2015, guessing at about 12k since rebuild.
- The old STRI X-Line read about 20 at idle, then failed.
- OEM gauge hasn't read any differently.
- New STRI DSD SLM II reads 10-12.
- Rotella T610w-40
VVT angle swings and oscillates at idle, target is pretty steady, angle improves with higher pressure after about 2000rpm.
Interesting update. I've been leaking oil and found that i had installed a bad valve cover gasket. It must have jumped out as i put it on the head and tightened the cover down. A small piece is nissing and either fell out of the engine when i lifted the cover off or it had already fallen into the head and possibly gotten sucked into the oil system.
Okay so VC gasket has been replaced, i tested oil pressure with a $25 amazon test kit, first test was same oil nothing added, low pressure even below temp. I was able to get the sensor out through the passenger side wheel well, that was enormously relieving because I didn't have to take my VICS manifold off. Second test was with 4 quarts of 10w-40, immediately had higher pressure at same temperature, I think my volume was low because I had been losing oil through the valve cover for a few days. Swapped digital gauge back in and went for a drive to get oil up to temp. Best I could do was 200* because roads are wet and traffic is heavy, knees weak arms spaghetti. At around 190-200* oil pressure was steady around 10 psi, with the oscillations to about 800 it didn't go lower than about 6 psi or so for the brief moment the rpms were that low. A few random dips to 500-600 rpm read no lower than 4 psi but rpms immediately went back up to normal range. If you guys have been running the same pump with similar pressures and no issues then I think I'm fine. I'm happy with the heavier oil weight, next change will be the real stuff, probably rotella T6 since that's what everyone seems to run - I picked up Napa stuff today because that's all they had in 40 weight.
Yes, I do feel better after conferring with you guys. When it drops pressure it's only briefly, it doesn't stay low and I have good pressure when driving. Salt accepted.
I autocrossed on Sunday and oil temp was around 210* after finishing and pressure stayed at around 10 with only a few dips. I shut it off and let it cool and on startup had good pressure 10-12.