Jacking up the motor with a Jack to change motor mounts
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Hello everyone.
Got a question. I would like to change motor mounts on my 1.6. I don't have a hoist so is it possible to just Jack the engine up with a floor Jack? I would put a piece of wood and maybe a piece of carpet to make sure I don't dent anything. Is this a BAD idea or someone done this before? I am really sick of my engine shaking like crazy when warming up and I practicaly can't shift to second above 5k, it's always a misshift.
Got a question. I would like to change motor mounts on my 1.6. I don't have a hoist so is it possible to just Jack the engine up with a floor Jack? I would put a piece of wood and maybe a piece of carpet to make sure I don't dent anything. Is this a BAD idea or someone done this before? I am really sick of my engine shaking like crazy when warming up and I practicaly can't shift to second above 5k, it's always a misshift.
Last edited by Rushin; 09-21-2009 at 11:52 AM. Reason: Wrong title!
#2
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
That will be fine.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#8
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Yes...3 hardassfucktogetout bolts per mount, that will take some finagling to get proper alignment back in.
Consider these in the "definitely ******* hand thread before tightening" category. That is unless you want to retap holes in the side of your block you can barely get to.
Use a lot of extensions and go in from wheel well...it's about like trying to penetrate hustler's sister.
Consider these in the "definitely ******* hand thread before tightening" category. That is unless you want to retap holes in the side of your block you can barely get to.
Use a lot of extensions and go in from wheel well...it's about like trying to penetrate hustler's sister.
#11
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Good write up. So I guess I will have to remove the mani and downpipe to get to the drivers side motor mount, right? If I absolutly have to do it, there is no way I am doing this until winter time.
#19
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Yeah, the realignment is a real ******* bitch. Jack up front of motor...jack up back of motor....pull on intake manifold...****!
That's why I stressed threading those bolts in by hand. You WILL be tempted to make it flush by getting threads started...and you WILL cross thread one this way since you'll be using a clusterfuck of every extension you and your neighbor own to get in there around fender, control arms, fender liner, starter and clutch lines.
Be patient.
That's why I stressed threading those bolts in by hand. You WILL be tempted to make it flush by getting threads started...and you WILL cross thread one this way since you'll be using a clusterfuck of every extension you and your neighbor own to get in there around fender, control arms, fender liner, starter and clutch lines.
Be patient.