Engine bearings
#41
Elite Member
iTrader: (3)
Join Date: Apr 2014
Location: Huntington, Indiana
Posts: 2,885
Total Cats: 616
I'll tell you in the morning what my machinist wants for it.
He left me a message today recommending a turn.
I have a spare, so I will probably use that to avoid ruining the hardening as guttedmiata mentioned, but I'll ask anyway.
He left me a message today recommending a turn.
I have a spare, so I will probably use that to avoid ruining the hardening as guttedmiata mentioned, but I'll ask anyway.
#46
ACL Race I know work flawlessly for High HP and RPM.
#47
Senior Member
iTrader: (1)
Join Date: Jan 2011
Location: Chattanooga, Tn
Posts: 1,234
Total Cats: 283
I'm 100% with Bob on this.
I'd say he and I have abused bearings as much or more than anyone...and I don't think either one of us would put anything other than ACLs in our motors if given the choice.
I would recommend spending the extra few bucks and send them to Calico to be coated.
I'd say he and I have abused bearings as much or more than anyone...and I don't think either one of us would put anything other than ACLs in our motors if given the choice.
I would recommend spending the extra few bucks and send them to Calico to be coated.
#48
maybe a stupid post (once again) and in wrong topic, but is that standard that the middle (3rd) main journal on the crank does not have an oil port hole ? It is out of a BPZE block.
and other question, I have the crank main and pin journals measured and it comes out as follow:
main:
1 - 49.934
2 - 49.935
3 - 49.932
4 - 49.934
5 - 49.938
All of which except nr. 5 is out of range by a very little, I believe bottom limit for BPZE is 49.938. Should I be worried about this little difference ? I guess a little extra room for thick oil is only a good thing with 8500RPM screamer isnīt it ? I am looking for about 0.045mm oil clearance for main bearings and 0.054mm for rod bearing
Also pins diameter:
1 - 44.935
2 - 44.933
3 - 44.933
4 - 44.938
limit there should be 44.940 and again I am under that by a hair. I plan to use King XP series bearings.
and other question, I have the crank main and pin journals measured and it comes out as follow:
main:
1 - 49.934
2 - 49.935
3 - 49.932
4 - 49.934
5 - 49.938
All of which except nr. 5 is out of range by a very little, I believe bottom limit for BPZE is 49.938. Should I be worried about this little difference ? I guess a little extra room for thick oil is only a good thing with 8500RPM screamer isnīt it ? I am looking for about 0.045mm oil clearance for main bearings and 0.054mm for rod bearing
Also pins diameter:
1 - 44.935
2 - 44.933
3 - 44.933
4 - 44.938
limit there should be 44.940 and again I am under that by a hair. I plan to use King XP series bearings.
Last edited by AndrewG; 02-04-2018 at 03:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post