Tach signal for racecapture pro (sanity check)
08-29-2017 | 11:28 AM
#1
Thread Starter
Junior Member
Joined: Nov 2014
Posts: 127
Total Cats: -16
From: Ypsilanti, MI
Tach signal for racecapture pro (sanity check)
Hey guys I just wanted to make sure I'm going to the right source for a tach signal to feed my race capture. I'm believe that I am pulling it from the diagnostic box on the drivers side of the car. I have a '91 1.6, the link below is where I'm getting my info.
https://forum.miata.net/vb/showthread.php?t=377677
https://forum.miata.net/vb/showthread.php?t=377677
Reply
0
0
08-31-2017 | 02:58 PM
#3
Senior Member
Joined: Apr 2017
Posts: 1,232
Total Cats: 169
From: Greeley, CO
A basic DMM can be used to identify a tach signal wire reliably. Switch the meter to AC voltage. Put one lead on chassis ground and the other lead on the tach wire. You will see a reading around 0.5-1 volt at idle and that measurement will increase with engine rpm.
Reply
0
0
