Singular Motorsports ECU Brackets
#110
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,429
Total Cats: 1,207
The beer fridge picture was subtly showing Singular's sticker, the light bulb.
These phantom coil brackets?
https://www.miataturbo.net/diy-turbo...d-82744/page4/
Also pictured, Ed's new VVT head.
These phantom coil brackets?
https://www.miataturbo.net/diy-turbo...d-82744/page4/
Also pictured, Ed's new VVT head.
#112
Ryan, please compare my MS Labs (Reverant) Basic MS3 and Singular Motorsports 90-93 ECU bracket to those pictured in quotes below. It seems that my bracket is much more narrow than others. I get that midpack has a 2004 so his bracket is different. But curly has a 1993 and his ECU seems to fit his bracket just fine?
Although the little 90* bracket feet fit my ECU case, there's no way my ECU will fit on the Singular Motorsports ECU bracket using those feet even if I turn them inside out and use low profile mounting screws. Ideally, my bracket would be at least 3" wider so that I can use the 90* bracket feet the way they're intended to be used.
Am I only supposed to be using 1 of the 2 bracket feet and supplementing with zip ties and/or velcro? Or did you change the design at some point? It's hard for me to tell from the picture but it looks like curly might be using only 1 of the brackets whereas midpack is using both. Is that the difference between the 90-93 and the 99+ brackets?
Although the little 90* bracket feet fit my ECU case, there's no way my ECU will fit on the Singular Motorsports ECU bracket using those feet even if I turn them inside out and use low profile mounting screws. Ideally, my bracket would be at least 3" wider so that I can use the 90* bracket feet the way they're intended to be used.
Am I only supposed to be using 1 of the 2 bracket feet and supplementing with zip ties and/or velcro? Or did you change the design at some point? It's hard for me to tell from the picture but it looks like curly might be using only 1 of the brackets whereas midpack is using both. Is that the difference between the 90-93 and the 99+ brackets?
#118
Supporting Vendor
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: San Diego
Posts: 3,304
Total Cats: 1,222
Less (projected) demand. The more complicated the solution needs to be, the more demand there will be for a well-designed solution that takes the guesswork out of the process for the customer and makes it a bolt-on affair. Of the three ECU locations, the 99+ is the worst/most difficult to mount an aftermarket unit, followed by the 90-93. The 94-97 location is much easier for a DIYer to mount an ECU in, by just screwing it into the rear bulkhead. I'm not saying that's a good way to do it, but because it can be done that way easily, less guys will opt to spend money on a dedicated bracket.