Mx-5 99 speeduino tune help
08-03-2021 | 03:39 PM
#1
Thread Starter
Newb
Joined: Aug 2021
Posts: 1
Total Cats: 0
Mx-5 99 speeduino tune help
Hello there!
A few days ago I installed speeduino to my 99' mx-5.
Everything is stock, but I have AEM 03-300 wideband installed.
I played with a base map a bit and tried to tune it so the AFR target is met. I also rescalled the map to 240kPa beacuse of turbo installation I will be performing in a couple of weeks.
What I can tell is that it starts very slow and then idles well.
The next problem is when I drive and try to blip on the gas the car doesn't respond quickly - I have to hold the gas for about second and then the rpm goes up. That makes RPM matching nearly impossible.
I know I have a lot to learn and I don't expect anyone on the forum to tune my car for me but if some of you can take a look at what I have done so far I'd really appreciate it.
Here is my current tune and log file.
A few days ago I installed speeduino to my 99' mx-5.
Everything is stock, but I have AEM 03-300 wideband installed.
I played with a base map a bit and tried to tune it so the AFR target is met. I also rescalled the map to 240kPa beacuse of turbo installation I will be performing in a couple of weeks.
What I can tell is that it starts very slow and then idles well.
The next problem is when I drive and try to blip on the gas the car doesn't respond quickly - I have to hold the gas for about second and then the rpm goes up. That makes RPM matching nearly impossible.
I know I have a lot to learn and I don't expect anyone on the forum to tune my car for me but if some of you can take a look at what I have done so far I'd really appreciate it.
Here is my current tune and log file.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
