BEGi NC Rear Mount Turbo
#1
Former Vendor
Thread Starter
Join Date: Jun 2006
Location: Bell Tuning & Performance
Posts: 1,337
Total Cats: -99
BEGi NC Rear Mount Turbo
Car Specs:
2006 MX5
GT2860RS
Custom IC
Custom Exhaust (what there is of it!)
Xede
550 cc Injectors
Tuning was done at Fastlane in Houston, TX. The car started off making 188 whp @ 6 psi. After tuning was done, the final result was 220 whp & 212 ft-lbs torque @ 8 psi. I was quite surprised at the response of this system. I would have expected some lag, partly due to the three catalytic converters on the car. But there really was not any. It's response was just as good (if not better) than any other Miata I have tuned. It was quite fun to drive.
A quick shout out to Fastlane for letting us invade your shop and being so cool about it. And to Jonny for his patience and perseverance.
Stephanie
2006 MX5
GT2860RS
Custom IC
Custom Exhaust (what there is of it!)
Xede
550 cc Injectors
Tuning was done at Fastlane in Houston, TX. The car started off making 188 whp @ 6 psi. After tuning was done, the final result was 220 whp & 212 ft-lbs torque @ 8 psi. I was quite surprised at the response of this system. I would have expected some lag, partly due to the three catalytic converters on the car. But there really was not any. It's response was just as good (if not better) than any other Miata I have tuned. It was quite fun to drive.
A quick shout out to Fastlane for letting us invade your shop and being so cool about it. And to Jonny for his patience and perseverance.
Stephanie
#2
Elite Member
iTrader: (15)
Join Date: Dec 2007
Location: San Antonio, Texas
Posts: 4,847
Total Cats: 27
You know, I know remote turbos have a bad rap, but based on a review I read recently about a successfully implemented turn-key rear mount turbo system for a Vette, I was wondering if y'all were going to go that route.
Congratulations on the NC system. From the m.n thread I know you guys have been working on it for awhile.
Congratulations on the NC system. From the m.n thread I know you guys have been working on it for awhile.
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Prefabbed Turbo Kits
216
03-22-2017 04:00 PM