Finally got my car on the dyno today at DynoSource Performance.

Car is a 2002 with an FM2 no electronics kit, FM 2.5 inch exhaust with no cat, squaretop, MS3PROpnp, FF 640 cc injectors, 180kpa of boost. Full details in my build thread.

Super happy with the number and curves especially for a mustang dyno. The operator said a stock STI puts down around the same 230hp on this dyno. Torque seems a little low though no? My EBC needs some work it would slowly creep to 180kpa instead of holding it from ~3500 rpm like it should. Log of all 3 runs and tune attached.


Dyno

 

Can a mod move this to dyno sheets, I must have clicked the wrong section. @sixshooter

 

Whp numbers are perfect for 10-11psi. Torque is normally higher but I like how flat the torque is. You could be making considerably more tq if you got all 180kpa at a lower rpm instead of boost creeping.

 

I can't move it without a computer so it will be Monday. I'm using the mobile app.