What is the maximum gay you can have?
#1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Gay being not straight. ![](https://www.miataturbo.net/images/smilies/ky.gif)
Ok I pulled my manifold and trubo off and am checking to see if I need to get it machined. What do you guys think? Personally I think if I can see light through a straight edge it needs it, but I'm not sure if it would seal up once it gets warm.
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113700-what-maximum-gay-you-can-have-1a9c3ma.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113701-what-maximum-gay-you-can-have-zfapjuw.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113702-what-maximum-gay-you-can-have-on7urnc.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113703-what-maximum-gay-you-can-have-grkphse.jpg?dateline=1400678465)
Also, where on this manifold do I need to make my relief cuts? Between 1-2 2-3 3-4 or just 1-2 3-4?
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113704-what-maximum-gay-you-can-have-mtibhen.jpg?dateline=1400678465)
Thanks!
![](https://www.miataturbo.net/images/smilies/ky.gif)
Ok I pulled my manifold and trubo off and am checking to see if I need to get it machined. What do you guys think? Personally I think if I can see light through a straight edge it needs it, but I'm not sure if it would seal up once it gets warm.
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113700-what-maximum-gay-you-can-have-1a9c3ma.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113701-what-maximum-gay-you-can-have-zfapjuw.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113702-what-maximum-gay-you-can-have-on7urnc.jpg?dateline=1400678465)
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113703-what-maximum-gay-you-can-have-grkphse.jpg?dateline=1400678465)
Also, where on this manifold do I need to make my relief cuts? Between 1-2 2-3 3-4 or just 1-2 3-4?
![](https://www.miataturbo.net/attachments/diy-turbo-discussion-14/113704-what-maximum-gay-you-can-have-mtibhen.jpg?dateline=1400678465)
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Prefabbed Turbo Kits
216
03-22-2017 04:00 PM
94mx5red
DIY Turbo Discussion
7
01-22-2007 12:20 PM