VICS operation - how to add
#42
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
What would the circuit need?
EDIT: quick search found this
http://www.diyautotune.com/diypnp/ap...0-18bp-mt.html
EDIT: quick search found this
http://www.diyautotune.com/diypnp/ap...0-18bp-mt.html
The VICS actuator should have vacuum at idle and changes state at 5000 RPM. We have used ALED as the output to control the VICS system at Connectorboard 4Q with RPM as a single output condition, a threshold of > 5000, a hysterisys of 300, "power on" set to 0, and "trigger value" set to 1. This all means that the output will activate at 5000 RPMs, won't turn back off until 4700 RPMs, is off when the MS is powred and the engine is started, and is activated when triggered
Last edited by buffon01; 04-20-2013 at 11:25 AM.
#44
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
relay control circuit
https://www.miataturbo.net/megasquir...ed-vics-32509/
https://www.miataturbo.net/megasquir...ed-vics-32509/
![Biggthumpup](https://www.miataturbo.net/images/smilies/biggthumpup.gif)
#48
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I know this is an old thread but I am working on installing the VICS but using race capture to run it instead of a RPM switch or megasquirt (still using factory 1.6 ecu). We have the script in the RCP correct and the wiring to the relay correct, However I dont think we wired the solenoid correctly. Can you guys tell me what the pinout of the solenoid is? I followed this thread to get the vacuum properly hooked up. Now just checking the wiring.
Thread
Thread Starter
Forum
Replies
Last Post
Lincoln Logs
Dynos and timesheets
4
09-23-2015 12:26 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM