Does anyone know where I can get a cast iron 1.6 taco taco turbomanifold from?

 

They are sold out on ebay which is one of the only places to get it.

Instead, buy a 1.8 and use this then tell me how it goes.

94 05 Mazda Miata MX5 1 8L DOHC T25 T28 Turbo Exhaust Header Manifold Cast Iron | eBay

 

Taco Taco is still a thing?

 

TacoTaco actually has 2 1.8 cast manifolds now. I think the difference is EWG or not, but I have not looked in a few weeks. I will probably end up picking one up sometime in the next few months to try out.

 

I think they have two flange offerings as well.
Budgeter MKtrubo kit?
It might make it easy to offer a kit for T2 turbos as well.

 

I just found a t3 flanged one. Honestly it would not change the cost of the kit any. I am also not sure if the turbo I use would fit with the v-band outlet. Might be to far back to build a downpipe and not hit the back shelf.

T2 setups are off the table. I don't like build the weird shaped outlets, and I can't find a reliable cheap t25 exit flange to 2.5" v-band pipe.

 

anyone test the burrito-burrito setup?

 

The quesadilla-quesadilla looks promising. 59% off!!!!

 

Tostada Tostada where it's at

 

Someone needs to buy one and put an EFR on it. Make vlad's head explode.

 

I don't think it will fit with a downpipe without significantly cutting the back shelf.

 

My shelf is cut and I'm using the cast flyin flyin miata miata manifold. Because I needed the Clarence.

 

I cut my shelf



Lars, if I buy one and ship it your way could you easily snap some clearance photos for us?

Thanks for moving the thread, kinda felt bad for totally stealing it.

 

I bought my cast 1.6 manifold (TaquitoTaquito?) from MiragePower2008 while TacoTaco didn't have any listed. I think they're the same seller as they even have what appears to be the same weird looking cast 1.8 manifold.94 05 Miata 1 8L Racing T2 T25 T28 Cast Iron Exhaust turbocharger Manifold Unit | eBay

 

https://www.miataturbo.net/build-thr...5/#post1167350

 

I have a 1.6 tacotaco manifold I no longer need now that I'm 1.8 swapped. $75 shipped? I put relief cuts in the flange for expansion and whatnot.

 

Yeah if you want to I can take some pictures of it on a NA and NB most likely. I probably won't pick one up for a while. I sort of splurged these past 4 days on a ton of other miata parts.

 

Dat club orange lyfe.

 

That is a large part, also buying a VVT motor and NB subframe. Honestly don't even know what the VVT motor is going to be used for. Probably a nice garage decoration on an engine stand, until I find a car to put it in.

 

If you wouldn't mind, that'd be sweet

I won't need it back for a while, anyway.