Stainless oil line trouble BEGI series 3

Reply Subscribe

Thread Tools

Search this Thread

10-13-2007 | 07:47 PM

drewbroo

Thread Starter

Senior Member

iTrader: (2)

Joined: May 2007

Posts: 502

Total Cats: 0

From: Tampa, Florida

Stainless oil line trouble BEGI series 3

I am having trouble getting the braided oil line in the fitting (Near the oil filter) on my 96 with the BEGI series 3 kit. Anyone have any suggestions?
THe angle of approach makes it kinda difficult.

10-13-2007 | 07:54 PM

neogenesis2004

Elite Member

iTrader: (12)

Joined: Aug 2006

Posts: 4,413

Total Cats: 20

Is that the spot where the oil pressure sender is? I have my feed there, is the fitting for sure 1/8" bsp

10-13-2007 | 09:41 PM

cjernigan

Elite Member

iTrader: (13)

Joined: Oct 2006

Posts: 8,091

Total Cats: 7

From: Atlanta, GA

If it's from BEGI it is for sure 1/8 BSP. Take your passenger side wheel off, you can access the side of the block easily through the fender well. Makes getting to the line on a snap.

10-13-2007 | 11:10 PM

drewbroo

Thread Starter

Senior Member

iTrader: (2)

Joined: May 2007

Posts: 502

Total Cats: 0

From: Tampa, Florida

Quote:

Originally Posted by cjernigan

If it's from BEGI it is for sure 1/8 BSP. Take your passenger side wheel off, you can access the side of the block easily through the fender well. Makes getting to the line on a snap.

already tried that route. Fitting fits, (It was tested before the block was put in)
its just a pain in the **** hitting it from that angle, and cant seem to get it to screw in.

10-14-2007 | 01:06 AM

Fritch

Senior Member

Joined: Mar 2005

Posts: 563

Total Cats: 0

From: Holiday, FL

you need nimble fingers and thin arms to play around in that area. It was really the most fun part of my install when I did it, took the most time for some reason