I have bought a used set of Splitfire COPs but the connector for my car did not come with the kit. According to the Splitfire website, it is PnP for use on a stock ECU in an NA6 or NB6 so I am planning to wire it up the same way to run with my MS3X.

The wires on the Splitfire kit are not the same colours as those on the car's harness and I can't find a wiring diagram for the Splitfire so I was hoping someone could tell me how they should be wired.

Looking from the back of the connector the coloured wires are:

White/Red--------Black/Red-----White

Yellow/White-----Red------------Yellow


I am planning on using the connector from an old NA6 coil pack and soldering it onto the Splitfire harness.


The kit


Igniter


Coils and plugs


Connector with attachment


Connector without the attachment


Wiring of the connector

Thanks!