Rear Turbo Setup
#1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Hi Everyone, First post here on MiataTurbo and would like to say hi. Hope you enjoy the post and pics.
So here's the Parts list:
Comp Turbo, Water Cooled Ceramic Bearings, no oil.
MSPNP Pro Here's a huge suggestion, make sure you lengthen the wires that are given to you by DIY Autotune so you can have easier hookup from the extra terminals in the back. Do the same with the vacuum line, put about 18" on it and run a barbed coupler to connect the one going through the firewall to the engine. If your afraid of it blowing off with boost super glue it. Don't put the super glue in the vacuum tube just on the barbed ends and slide them on, they won't come off.
Tial waste gate
Turbosmart BOV.
Custom charge pipe by me, I have a bender.
Custom exhaust, I have mig and tig.
GM IAT sender.
MS electronic boost controller
Extra GM 3 bar map sensor for exhaust back pressure reading. Have not taken any readings yet.
LM1 wideband setup.
2" tubing
Lots of good turbo hose clamps
So here's the Parts list:
Comp Turbo, Water Cooled Ceramic Bearings, no oil.
MSPNP Pro Here's a huge suggestion, make sure you lengthen the wires that are given to you by DIY Autotune so you can have easier hookup from the extra terminals in the back. Do the same with the vacuum line, put about 18" on it and run a barbed coupler to connect the one going through the firewall to the engine. If your afraid of it blowing off with boost super glue it. Don't put the super glue in the vacuum tube just on the barbed ends and slide them on, they won't come off.
Tial waste gate
Turbosmart BOV.
Custom charge pipe by me, I have a bender.
Custom exhaust, I have mig and tig.
GM IAT sender.
MS electronic boost controller
Extra GM 3 bar map sensor for exhaust back pressure reading. Have not taken any readings yet.
LM1 wideband setup.
2" tubing
Lots of good turbo hose clamps
Last edited by Roadstercycle; 12-16-2015 at 10:12 PM.
#15
Junior Member
iTrader: (1)
Join Date: Oct 2015
Location: Metro Detroit, MI
Posts: 397
Total Cats: 36
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
This is awesome and I just can't fault you for doing something different and unique. My only wonder is how the spool and pressure drop is going to be considering how far the air has to go. Especially since the charge air is travelling a couple inches away from the hot exhaust. Still a badass setup imo