M8 Turbo Studs, M10 Turbine Housing?
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2014
Location: Silver Spring, MD
Posts: 659
Total Cats: -15
M8 Turbo Studs, M10 Turbine Housing?
Kraken manifold I have has M8 studs for the turbo flange. Used SR20 turbo I bought turned out to have the holes in the turbine flange drilled for M10 hardware. Options for making this work, other than getting the manifold flange drilled and tapped for M10?
Does anyone make studs that are M8 on one end and M10 on the other? Or just get some metal tubing that's 8mm ID and 10mm OD and make up some bushings to slip on the studs?
Does anyone make studs that are M8 on one end and M10 on the other? Or just get some metal tubing that's 8mm ID and 10mm OD and make up some bushings to slip on the studs?
#2
Kraken manifold I have has M8 studs for the turbo flange. Used SR20 turbo I bought turned out to have the holes in the turbine flange drilled for M10 hardware. Options for making this work, other than getting the manifold flange drilled and tapped for M10?
Does anyone make studs that are M8 on one end and M10 on the other? Or just get some metal tubing that's 8mm ID and 10mm OD and make up some bushings to slip on the studs?
Does anyone make studs that are M8 on one end and M10 on the other? Or just get some metal tubing that's 8mm ID and 10mm OD and make up some bushings to slip on the studs?
#4
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2014
Location: Silver Spring, MD
Posts: 659
Total Cats: -15
These exist. This is just an example since I don't know what thread pitch you need.
https://www.amazon.com/10-M10-Double.../dp/B00KCBLI12
https://www.amazon.com/10-M10-Double.../dp/B00KCBLI12
Are Inconel studs required for a small street turbo setup?
#5
I made mine. here is a pretty close off the shelf solution: https://www.mcmaster.com/#standard-m...ubing/=1dl1sw3
part number 89895K736
part number 89895K736
mcmaster is really smart. part numbers produce hyperlinks..
#7
not sure but there is a big 'ol toll free phone number at the top of the page.
but youre in MD so like 5 -10 bucks i think. compair to machine time to custom make them, its a drop in the bucket.
ps, you deserve another negi-cat for such a retarded response after the spoon feed session. But ill spare you.
but youre in MD so like 5 -10 bucks i think. compair to machine time to custom make them, its a drop in the bucket.
ps, you deserve another negi-cat for such a retarded response after the spoon feed session. But ill spare you.
Thread
Thread Starter
Forum
Replies
Last Post
Cody Strife
DIY Turbo Discussion
32
08-03-2009 07:00 PM