Internal wastegate actuator for Greddy td04H
#1
Internal wastegate actuator for Greddy td04H
Yo , i have a question for my turbo. i'm running Greddy td04H at 10psi ( 1.6 stock) , ms2ench by mslabs with boost solenoid. greddy's wastegate internal was too small ( 0.35 bar ) so i put internal from garrett 2560. after few mount , ( maybe internal who i put was damaged) it started to make some over boost. I used another solenoid ( because I think it was the problem) the new solenoid was tha same luck . so I believe the problem was in my internal wastegate. what internal wastegate actuator you think was better for my setup? thanks and sorry for my bad English. Thanks a lot.
#4
You need to use the original GReddy wastegate. You can adjust the wastegate rod tighter and that will keep the flapper closed which will improve boost response. Using an actuator from a Garrett isnt going to work out nearly as well since the travel of the wastegate rod might be different than the td04H part.
Thread
Thread Starter
Forum
Replies
Last Post
NothinBuddaDreamer
DIY Turbo Discussion
7
03-26-2017 08:04 PM
miataspeed2005
DIY Turbo Discussion
15
06-07-2009 10:26 PM