Inspired by 18psi...My Exhaust
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Dec 2007
Location: Chattanooga, TN
Posts: 185
Total Cats: -1
Inspired by 18psi...My Exhaust
To match my 3" downpipe, I needed a 3" exhaust...
One 2 bolt 3" universal exhaust flange
4' of 3" 16 guage aluminized steel
1x 45 on a 4" radius
1x 90 on a 4" radius
1x 7" magnaflow round
1x stainless 90 on 4" radius
Put all of these together and what do you get?
One 2 bolt 3" universal exhaust flange
4' of 3" 16 guage aluminized steel
1x 45 on a 4" radius
1x 90 on a 4" radius
1x 7" magnaflow round
1x stainless 90 on 4" radius
Put all of these together and what do you get?
#11
Junior Member
Thread Starter
iTrader: (4)
Join Date: Dec 2007
Location: Chattanooga, TN
Posts: 185
Total Cats: -1
Yeah, I'll be sure and check my coolant lines...Fingers crossed. Turned out pretty well for my first exhaust I think. I wanted the tip pointed down a little, It does look a little odd right now, but I think when it's on the ground it will look just right. Should flow great... I'll get vids when I start the car, should be in the next day or two. First time starting it with the turbo, still gotta reflash the MS and install the IAT.
#19
Junior Member
Thread Starter
iTrader: (4)
Join Date: Dec 2007
Location: Chattanooga, TN
Posts: 185
Total Cats: -1
Well, this may be my first exhaust, but I have worked in a fab shop... It's not too loud for my taste. I'm waiting on a heater hose and some heat sheathing, but when I get those in I'll take some vids and post them. Should be next week some time. Then off to the dyno! (fingers crossed)
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM