Finally some work done. Olderguy o2 wire help please...
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2006
Location: Tucson "it's 110º" Arizona
Posts: 1,017
Total Cats: 0
Finally some work done. Olderguy o2 wire help please...
Finally got some quality time in.
Bipes is installed. A little but nothing serious. Gotta use the grape.
Thanks to whoever recommended taking the seat out for installation. I spent 10 minutes hunched over like an idiot before I remembered the idea.
Question: I'm installing the o2 clamp and confusing myself where the wires connect on the ECU. Power and ground I've got, but the other two?
As far as the rest. I've mounted the turbo and mocked up the piping, and think I'm satisfied. After three different orientations, this one is the most pleasing. We'll see.
Problems are: piping for the BOV recirculation, and I've clocked the turbo so I need to reposition the wastegate actuator. This means tapping the compressor. Once again, we'll see... \/ \/ Actually correct for once
Bipes is installed. A little but nothing serious. Gotta use the grape.
Thanks to whoever recommended taking the seat out for installation. I spent 10 minutes hunched over like an idiot before I remembered the idea.
Question: I'm installing the o2 clamp and confusing myself where the wires connect on the ECU. Power and ground I've got, but the other two?
As far as the rest. I've mounted the turbo and mocked up the piping, and think I'm satisfied. After three different orientations, this one is the most pleasing. We'll see.
Problems are: piping for the BOV recirculation, and I've clocked the turbo so I need to reposition the wastegate actuator. This means tapping the compressor. Once again, we'll see... \/ \/ Actually correct for once
#2
The O2 clamp should.... you first "cut" the factor O2 wire near the ECU....
one wire going to the ECU (instead of) the factory O2 signal wire....
and the other wire should go to the Sensor feed of the O2 sensor....
O2 Clamp
E | |
C ______| |_________Wiring from car's harness (aka from sensor)
U
Dave,
one wire going to the ECU (instead of) the factory O2 signal wire....
and the other wire should go to the Sensor feed of the O2 sensor....
O2 Clamp
E | |
C ______| |_________Wiring from car's harness (aka from sensor)
U
Dave,
Thread
Thread Starter
Forum
Replies
Last Post
JacksonRacingEngines
Engine Performance
10
09-10-2015 09:52 AM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM