DIY Turbo Discussion greddy on a 1.8? homebrew kit?

Engine Cutting out in boost

Thread Tools
 
Search this Thread
 
Old 08-05-2018 | 09:32 PM
  #21  
phipplet's Avatar
Thread Starter
Newb
 
Joined: Apr 2018
Posts: 10
Total Cats: 0
Default

Originally Posted by SpartanSV
Yeah MAT can't possibly be staying at 70 the entire time. You need to give TS info about your sensors.

https://trubokitty.com/#/tune

Bottom of that page has instructions.

VEAL works fine when you set everything up correctly.
Thank you very much! The car seems to running great now! It was pulling very nice! I guess lesson learned. I need to followed the instructions and setup a little more closely! Thanks again
Old 08-15-2018 | 07:07 PM
  #22  
2jz_mickey's Avatar
Junior Member
 
Joined: Jul 2017
Posts: 73
Total Cats: 3
Default

I had tye same issue! If it goes lean when you hit the "limiter" then you are experiencing spark blowout. Get a set of bkr7e plugs gapped to 30 thou (someone might correct) and you should be good. Did this with my ls coils and can confirm that it runs perfect now... Other than the occasional boost cut here and there 😂
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
NASSEX
Engine Performance
21
06-21-2019 11:34 PM
DNMakinson
MEGAsquirt
2
11-08-2017 05:44 PM
admtn2
DIY Turbo Discussion
23
12-03-2009 05:11 PM
N3v
MEGAsquirt
9
05-13-2009 12:43 PM
IcantDo55
MEGAsquirt
11
04-17-2008 01:38 PM




All times are GMT -4. The time now is 04:20 AM.