Can't find a M16x1.5 turbo coolant fitting.
#1
Can't find a M16x1.5 turbo coolant fitting.
I'm trying to find two M16x1.5 water coolant fittings for my T3 turbo. I don't care if they're a banjo bolt assembly or just fittings. The only type I've found have an AN fitting on the other end and I just want to be able to slip the hose on, not create a whole AN hose assembly.
I never thought it would be so difficult finding these fittings. Any suggestions?
I never thought it would be so difficult finding these fittings. Any suggestions?
#2
Senior Member
iTrader: (6)
Join Date: Mar 2005
Location: Sammamish, Washington
Posts: 1,396
Total Cats: 0
You may have to use a fitting that is 16X1.5 to -6 male. You can add a pair of -6 90's and then just slip your hoses on the end without using the compression collar. Just use a hose clamp. No braided hose needed.
#4
Senior Member
iTrader: (6)
Join Date: Mar 2005
Location: Sammamish, Washington
Posts: 1,396
Total Cats: 0
Check out my post in here for another water line option. This is my favorite way to go.
https://www.miataturbo.net/forum/t31579/
https://www.miataturbo.net/forum/t31579/
#5
AN PLUMBING.COM Earls performance products, Hose ends Hose,Adapters, fittings
They sell adapters here. Order everything you'll ever need from him at one time otherwise constant reorders will screw you in shipping.
They sell adapters here. Order everything you'll ever need from him at one time otherwise constant reorders will screw you in shipping.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM