Begi cast mani and t25 dont like each other
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2010
Location: Cary, NC
Posts: 494
Total Cats: 6
Begi cast mani and t25 dont like each other
So I finally got everything for my turbo build and I was just dry fitting everything and realized the studs on my mani are bigger than the holes on the turbine inlet. Is it safe to drill out the holes? Wasn't sure if that would cause cracking down the road. Also the compressor outlet would be hitting it so I'll have to clock it. I'm sure other people have had the same problem so I was wondering if anyone had a good source for a wastegate bracket that would work on a t25.
Thanks,
Chad
Thanks,
Chad
#10
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2010
Location: Cary, NC
Posts: 494
Total Cats: 6
Jeff, I already have a bracket. I guess i wasn't specific enough. I need a bracket relocation bracket I guess you would call it ha. Unless I am mistaken, that looks like a stock replacement bracket? I guess most people have the compressor clocked to aim toward the front driver side but that seems like the housing would interfere with the wastegate operation but if I had the outlet aimed straight down wouldn't have any clearance issues? My car is at my parents house so I can't go check
#11
http://www.bellengineering.net/produ...roducts_id=332
I got this. I had to drill into the Compressor housing and tap the holes to bolt it up but it is doable.
I got this. I had to drill into the Compressor housing and tap the holes to bolt it up but it is doable.
Thread
Thread Starter
Forum
Replies
Last Post