1999 Mazda Miata - $$9,700
#1
Thread Starter
Senior Member
iTrader: (7)
Joined: Jul 2007
Posts: 1,047
Total Cats: 1
From: Milpitas, CA
1999 Mazda Miata - $$9,700
Category: Import
Status: Clean Title
I have a 1999 Mazda Miata for sale, in USA - California.
Mileage: 182000 miles
Asking price is $9,700
After I go back to school, I realize that this car will just sitting in the garage when I can really use the money for school and paying off bills. *Due to this, it's best in my interest that this thing goes to a good home. *So heres the break down on whats included.
Suspension/Chassis Work:
Brain Storm Rollbar
Boss frog arms
FM frame rails
Rear Cannon Brace
TEIN Flex Coilovers 7/6
TEIN EDFC
Engine Mods:
RoadsterSport Turbo Midpipe
RoadsterSport 3 Muffler
AVO Turbo Kit GT2554R
Manual EBC
440CC RC Injectors (Cleaned and Flowed)
MS2 with PNP Board
COP Conversion
AEM UEGO WB
MSKnockSense
Real Oil Pressure Gauge Modification
Stop/Go Mods (Drivetrain):
Wilwood 4-pot Dynalite Kit Fronts - Trackspeed
Wilwood Brake Proportioning Valve + fittings
Fidanza 9.7lbs Alu Flywheel
6-puck Clutch
Stock 4.3 R&P with Torsen
Exterior/Interior Mods:
SportMAX 501 - 15x8 +15 Offset Gold with Falken Ziex 912
2001+ Headlight Conversion
2001 AP2 Large Skirts and Mudflaps
HID 6000k
Glowshift Boost and EGT Gauge
TrackDog Angled DIN Gauge Mounts
Greddy CARB Plate - Priceless ^_^
Spare/Not Installed:
Spare 99' Short Block
M-Tuned Rods
3 Supertech 9.5:1 Compression Pistons
Innovate LC-1 (Spare)
Glowshift Boost and EGT Gauge
Vishnu Dual-Feed Fuel Rail
Time and effort in putting this car together and installing it was tough, all the endless nights and hours getting it to run right. *I know I hate to do this, but it has to go. *Some of the parts are not installed yet, and they are ready to go.
ASKING PRICE: *$9,700
Obligatory Pictures:
Megasquirt-II Built by your's truly, and PNP Board Standalone:
I'll try to get some engine shots later. *Thanks guys.
Status: Clean Title
I have a 1999 Mazda Miata for sale, in USA - California.
Mileage: 182000 miles
Asking price is $9,700
After I go back to school, I realize that this car will just sitting in the garage when I can really use the money for school and paying off bills. *Due to this, it's best in my interest that this thing goes to a good home. *So heres the break down on whats included.
Suspension/Chassis Work:
Brain Storm Rollbar
Boss frog arms
FM frame rails
Rear Cannon Brace
TEIN Flex Coilovers 7/6
TEIN EDFC
Engine Mods:
RoadsterSport Turbo Midpipe
RoadsterSport 3 Muffler
AVO Turbo Kit GT2554R
Manual EBC
440CC RC Injectors (Cleaned and Flowed)
MS2 with PNP Board
COP Conversion
AEM UEGO WB
MSKnockSense
Real Oil Pressure Gauge Modification
Stop/Go Mods (Drivetrain):
Wilwood 4-pot Dynalite Kit Fronts - Trackspeed
Wilwood Brake Proportioning Valve + fittings
Fidanza 9.7lbs Alu Flywheel
6-puck Clutch
Stock 4.3 R&P with Torsen
Exterior/Interior Mods:
SportMAX 501 - 15x8 +15 Offset Gold with Falken Ziex 912
2001+ Headlight Conversion
2001 AP2 Large Skirts and Mudflaps
HID 6000k
Glowshift Boost and EGT Gauge
TrackDog Angled DIN Gauge Mounts
Greddy CARB Plate - Priceless ^_^
Spare/Not Installed:
Spare 99' Short Block
M-Tuned Rods
3 Supertech 9.5:1 Compression Pistons
Innovate LC-1 (Spare)
Glowshift Boost and EGT Gauge
Vishnu Dual-Feed Fuel Rail
Time and effort in putting this car together and installing it was tough, all the endless nights and hours getting it to run right. *I know I hate to do this, but it has to go. *Some of the parts are not installed yet, and they are ready to go.
ASKING PRICE: *$9,700
Obligatory Pictures:
Megasquirt-II Built by your's truly, and PNP Board Standalone:
I'll try to get some engine shots later. *Thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post