1991 Mazda Miata - $13500 OBO
#1
1991 Mazda Miata - $13500 OBO
Category: Import
Status: Clean Title
I have a 1991 Mazda Miata for sale, in USA - New York.
Mileage: 106900 miles
VIN: JM1NA3519M1215494
Engine Size: 1720cc
Asking price is $13500 OBO
REDACTED <- CL Link
Insanely built 1991 Turbo Mazda Miata
Clean, Adult Built and Driven, Reliable Car for Daily Driver or Weekend Autocross/Track/Drift
Almost $30k invested -- Nothing Overlooked, Have Receipts
Approximately 300 HP at full boost, completely tunable
106,000mi on chassis
Only 7,000mi on engine and turbo
Recently passed NYS inspection
Clean title in hand, car is registered and ready to sell
MANY extras if picked up locally (NY, 14224), just ask.
Engine:
- Imported Mazda B6 1.6L DOHC
- Professionally Dipped, Magnafluxed, and Decked Before Rebuild
- Bored and Stroked to 1720cc
- Wiseco 9:1 Compression Forged Pistons
- Crower Billet Connecting Rods
- Balanced and Ground Crank
- Ported and Polished Head w/ 3 Angle Valve Seats
- All New Seals, Gaskets, Bearings, Pumps, Etc..
- ARP Head and Main Studs
- 440cc RC Engineering Saturated Injectors
- Aluminum Extruded and Balanced Dual Feed Fuel Rail
- Bosch 4 Wire O2 Sensor
- NGK Iradium Spark Plugs
- Nology Hotwires Grounded Plug Wires
- Flyin' Miata Knock Sensor
- Mazda Competition Motor Mounts
Turbo:
- Mitsubishi TD04H-15G Turbocharger @ 18psi
- Mitsubishi Starion IC
- Custom Over-the-Radiator Intercooler Pipes
- Racing Mazda 2.5" Downpipe with Flex Joint
- 2.5" SS Enthuza Turbo Racer M1 w/ Borla XS Muffler
- 2.5" Racing Mazda Test Pipe
- HKS SSQV Blow Off Valve (loud!!)
- Flyin' Miata Electronic Boost Controller
- Flyin' Miata Stainless Steel Heat Shield
- Oil Return Direct to Oil Pan
Other Performance:
- Flyin' Miata Link Fully Programmable ECU
- USB Port Uplink for Laptop Interface (will provide tuning software on USB drive FREE)
- Walbro 255 HP Fuel Pump
- Fidanza Aluminum 1.8L Flywheel
- ACT XT 1.8L Clutch
- K&N Air Filter
- Goodwin Racing Willwood 4-piston Caliper Type IV Big Brake Kit
- Koyo 37mm Full Aluminum Racing Radiator
Suspension:
- '01 Mazda Miata Torsen 4.10:1 LSD
- Spax RSX Fully Adjustable Coil Over Kit
- Flyin' Miata Sway Bars
- Flyin' Miata Rear Subframe Brace
Exterior:
- Color: Mazda RX-8 Velocity Red
- ViS Type RE Front Bumper
- Robbins Sunfast Top with Glass Window (only 2 years old)
- Rota Grid Gunmetal 15x6.5 Rims
- Falken Azenis RS Sport Tyres 205/50 R15
- Hard Dog Xtreme Roll Bar
- Turn Signal Air Intakes
- Moss Motors Low Profile Dual Headlight System
- Hella Projector Angel Eye Fog Lights
- Clear Corner Markers
- Miata Scripted Stainless Steel Door Sill Plates
- 911 Turbo Badge
Interior:
- Corbeau Forza Racing Seat (have passenger racing seat if desired as well)
- Corbeau 4 Point Bolt-In Harnesses
- Jackson Racing A Pillar Dual Gauge Pod
- Defi Blue Racer Boost Gauge
- AEM Wideband O2 Sensor and Digital Gauge
- Solo Luna Shift ****
- KG Works Type S Push Button Starter Unit
Notes: I have owned this car since 2003. I bought it in California and had it shipped to Buffalo. It's been my baby and project ever since. I do not get a chance to drive it nearly as much as I'd like to so I think it's time to move on. The car was never abused, driven in snow or rain, and kept under a cover as much as possible. It'll be sad to see her go but I know someone else will enjoy her as much as I have.
I have nearly $30k invested in her over the years. Asking price is $13,500, and is negotiable. Please keep offers reasonable. Call or text Chris at REDACTED
Car is located in REDACTED
Thanks for looking. If you have any questions, please ask!!
Status: Clean Title
I have a 1991 Mazda Miata for sale, in USA - New York.
Mileage: 106900 miles
VIN: JM1NA3519M1215494
Engine Size: 1720cc
Asking price is $13500 OBO
REDACTED <- CL Link
Insanely built 1991 Turbo Mazda Miata
Clean, Adult Built and Driven, Reliable Car for Daily Driver or Weekend Autocross/Track/Drift
Almost $30k invested -- Nothing Overlooked, Have Receipts
Approximately 300 HP at full boost, completely tunable
106,000mi on chassis
Only 7,000mi on engine and turbo
Recently passed NYS inspection
Clean title in hand, car is registered and ready to sell
MANY extras if picked up locally (NY, 14224), just ask.
Engine:
- Imported Mazda B6 1.6L DOHC
- Professionally Dipped, Magnafluxed, and Decked Before Rebuild
- Bored and Stroked to 1720cc
- Wiseco 9:1 Compression Forged Pistons
- Crower Billet Connecting Rods
- Balanced and Ground Crank
- Ported and Polished Head w/ 3 Angle Valve Seats
- All New Seals, Gaskets, Bearings, Pumps, Etc..
- ARP Head and Main Studs
- 440cc RC Engineering Saturated Injectors
- Aluminum Extruded and Balanced Dual Feed Fuel Rail
- Bosch 4 Wire O2 Sensor
- NGK Iradium Spark Plugs
- Nology Hotwires Grounded Plug Wires
- Flyin' Miata Knock Sensor
- Mazda Competition Motor Mounts
Turbo:
- Mitsubishi TD04H-15G Turbocharger @ 18psi
- Mitsubishi Starion IC
- Custom Over-the-Radiator Intercooler Pipes
- Racing Mazda 2.5" Downpipe with Flex Joint
- 2.5" SS Enthuza Turbo Racer M1 w/ Borla XS Muffler
- 2.5" Racing Mazda Test Pipe
- HKS SSQV Blow Off Valve (loud!!)
- Flyin' Miata Electronic Boost Controller
- Flyin' Miata Stainless Steel Heat Shield
- Oil Return Direct to Oil Pan
Other Performance:
- Flyin' Miata Link Fully Programmable ECU
- USB Port Uplink for Laptop Interface (will provide tuning software on USB drive FREE)
- Walbro 255 HP Fuel Pump
- Fidanza Aluminum 1.8L Flywheel
- ACT XT 1.8L Clutch
- K&N Air Filter
- Goodwin Racing Willwood 4-piston Caliper Type IV Big Brake Kit
- Koyo 37mm Full Aluminum Racing Radiator
Suspension:
- '01 Mazda Miata Torsen 4.10:1 LSD
- Spax RSX Fully Adjustable Coil Over Kit
- Flyin' Miata Sway Bars
- Flyin' Miata Rear Subframe Brace
Exterior:
- Color: Mazda RX-8 Velocity Red
- ViS Type RE Front Bumper
- Robbins Sunfast Top with Glass Window (only 2 years old)
- Rota Grid Gunmetal 15x6.5 Rims
- Falken Azenis RS Sport Tyres 205/50 R15
- Hard Dog Xtreme Roll Bar
- Turn Signal Air Intakes
- Moss Motors Low Profile Dual Headlight System
- Hella Projector Angel Eye Fog Lights
- Clear Corner Markers
- Miata Scripted Stainless Steel Door Sill Plates
- 911 Turbo Badge
Interior:
- Corbeau Forza Racing Seat (have passenger racing seat if desired as well)
- Corbeau 4 Point Bolt-In Harnesses
- Jackson Racing A Pillar Dual Gauge Pod
- Defi Blue Racer Boost Gauge
- AEM Wideband O2 Sensor and Digital Gauge
- Solo Luna Shift ****
- KG Works Type S Push Button Starter Unit
Notes: I have owned this car since 2003. I bought it in California and had it shipped to Buffalo. It's been my baby and project ever since. I do not get a chance to drive it nearly as much as I'd like to so I think it's time to move on. The car was never abused, driven in snow or rain, and kept under a cover as much as possible. It'll be sad to see her go but I know someone else will enjoy her as much as I have.
I have nearly $30k invested in her over the years. Asking price is $13,500, and is negotiable. Please keep offers reasonable. Call or text Chris at REDACTED
Car is located in REDACTED
Thanks for looking. If you have any questions, please ask!!
Last edited by Braineack; 07-15-2014 at 10:00 AM. Reason: Added CL Link
#3
Thanks man, I'm still looking for that cat. I'll let you know ASAP!!
#5
So you don't post anything here for 7 years, then you have the ***** to post this 1.6L miata with a plethora of sub-par parts here for this amount of money?
I won't allow it. I won't let my subjects fall victim to you; only me.
$4K car tops, on a good day, when every other miata in the world has been sold first.
GTFO.
I won't allow it. I won't let my subjects fall victim to you; only me.
$4K car tops, on a good day, when every other miata in the world has been sold first.
GTFO.
#6
300hp on 440cc squirters, and a greddy turbo.... muahahaha....ha....hahaha....haha
I love the Quality Control Bot... He saved my life.... i had 13k in my hand, about to hand it over. Thank you Banhammer Weilding Kitty!!!!
I love the Quality Control Bot... He saved my life.... i had 13k in my hand, about to hand it over. Thank you Banhammer Weilding Kitty!!!!
#8
I knew i was thinking it looked like a car i had seen.... just couldnt quite put my finger on it. lmao
Thread
Thread Starter
Forum
Replies
Last Post