Y8s put his spec all over me and I liked it. (exhaust build)
#65
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Whatever gas you are using the welds look good.
In your pics you have some pretty good gap in the tubes. The recent exhaust work I have done I butted the tubes together. I found I was able to turn the heat up a bit and get better heat penetration without burn through. I figure this is okay since exhaust is not structural. What are your thoughts.
Kind of off topic, But I think I am going to build a second exhaust with a smaller muffler and build as straight a system as possible. Then I will take both exhaust to the dyno to test
In your pics you have some pretty good gap in the tubes. The recent exhaust work I have done I butted the tubes together. I found I was able to turn the heat up a bit and get better heat penetration without burn through. I figure this is okay since exhaust is not structural. What are your thoughts.
Kind of off topic, But I think I am going to build a second exhaust with a smaller muffler and build as straight a system as possible. Then I will take both exhaust to the dyno to test
#67
2 Props,3 Dildos,& 1 Cat
![](/mt2011/images_td/ranks/supporter1.gif)
![](/mt2011/images_td/ranks/smod.png)
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Whatever gas you are using the welds look good.
In your pics you have some pretty good gap in the tubes. The recent exhaust work I have done I butted the tubes together. I found I was able to turn the heat up a bit and get better heat penetration without burn through. I figure this is okay since exhaust is not structural. What are your thoughts.
Kind of off topic, But I think I am going to build a second exhaust with a smaller muffler and build as straight a system as possible. Then I will take both exhaust to the dyno to test
In your pics you have some pretty good gap in the tubes. The recent exhaust work I have done I butted the tubes together. I found I was able to turn the heat up a bit and get better heat penetration without burn through. I figure this is okay since exhaust is not structural. What are your thoughts.
Kind of off topic, But I think I am going to build a second exhaust with a smaller muffler and build as straight a system as possible. Then I will take both exhaust to the dyno to test
also, I had to spend some time filling brain's burn through hole when he was learning to weld.
#70
Boost Czar
![](/mt2011/images_td/ranks/supporter1.gif)
![](/mt2011/images_td/ranks/admin.png)
Thread Starter
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,607
Total Cats: 4,102
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
this we did, look here again:
![](http://www.boostedmiata.com/gallery2/d/11332-2/DSC_0013.JPG)
we beveled, "chamffered," the edges with the flat side of the chop saw.
or would chamffering be doing that to one pipe and having the other sit overtop?
we beveled, "chamffered," the edges with the flat side of the chop saw.
or would chamffering be doing that to one pipe and having the other sit overtop?
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
7
11-03-2015 01:51 PM
SuperSneakySecretSquirrel
Meet and Greet
5
09-06-2015 08:30 PM