Originally Posted by aidandj
(Post 1284057)
I'm using ABS all around because I'm doing an ABS swap. If you got it just right you could use ABS up front and VSS for the rear.
Originally Posted by aidandj
(Post 1284057)
Boost by gear is easy, and only requires VSS.
|
2 Attachment(s)
It uses VSS and it works perfectly. I run like 8psi in second, and barely lose traction up top. Then full boost in 3rd and up because peasant torque.
I just realized I might need to adjust my pulse per mile because different rear end ratio. Hmmm. https://www.miataturbo.net/attachmen...ine=1447697369 https://www.miataturbo.net/attachmen...ine=1447697369 |
Originally Posted by EO2K
(Post 1284056)
I do not, but I should. Boost by gear and traction control always been part of the plan.
I'm still trying to figure out if I need a rear ABS upright or if I can just use the VSS for traction control. Go make this work so I can copy you. --Ian |
Unfortunately I don't make RaceLogic money :P
|
as soon as you update to firmware that properly controls CL boost, boost by gear should work fine
|
Originally Posted by 18psi
(Post 1284068)
as soon as you update to firmware that properly controls CL boost, boost by gear should work fine
|
Its easy
|
Originally Posted by EO2K
(Post 1284067)
Unfortunately I don't make RaceLogic money :P
--Ian |
Originally Posted by aidandj
(Post 1284070)
Its easy
|
Upgrade to 1.4 Copy list of errors.
Edit the MSQ manually for each error. Profit |
FWIW, my upgrade from 1.3.4 to 1.4.0 went smoothly with no issues. Needed to retune the initial value (now bias) table, but that was it.
--Ian |
Fine, I'll do it on Saturday and you all can watch me suffer and whine for help all weekend.
|
I'll make sure to disconnect my phone :laugh:
jkjk |
I'll be out of town :giggle:
|
Originally Posted by EO2K
(Post 1284059)
I need daddy monk to find me an ABS donor car :facepalm:
I took the entire rear subframe, and I don't need ABS. Aidan; I haven't forgotten you little buddy. You'll get all your parts soon. |
Possibruu... Aidan says I don't need it though. Wouldn't I need the pair? And the axles?
Curse Ed and his actually swapping over the ABS :giggle: |
Its worth trying with just VSS.
You only need one for VSS 2 for ABS |
You only need the upright for the sensor mounts.
The only difference in the axles is the ring, which just presses on. I don't think the axles are different otherwise. Lemme take some pics. |
|
Originally Posted by aidandj
(Post 1284149)
Its worth trying with just VSS.
Originally Posted by aidandj
(Post 1284149)
You only need one for VSS 2 for ABS
|
All times are GMT -4. The time now is 01:37 PM. |
© 2024 MH Sub I, LLC dba Internet Brands