The Eppic Offroadster
#201
Junior Member
Thread Starter
Join Date: Nov 2016
Location: Steinbach, Manitoba
Posts: 116
Total Cats: 52
First Batch of HD pictures done!
Starting with my favorite
and then the other good ones.
Father and Son centerfold?
Had to give dad a go in my car. Where do you think i get all my skillz from? He's the real OG.
Nothing better than hanging with your mates at a big ol party full of rednecks.
A good time was had by all. Such a great time. Next year will be even crazier. My brain is turning already.
Starting with my favorite
and then the other good ones.
Father and Son centerfold?
Had to give dad a go in my car. Where do you think i get all my skillz from? He's the real OG.
Nothing better than hanging with your mates at a big ol party full of rednecks.
A good time was had by all. Such a great time. Next year will be even crazier. My brain is turning already.
#203
Junior Member
Thread Starter
Join Date: Nov 2016
Location: Steinbach, Manitoba
Posts: 116
Total Cats: 52
Got some more work done this weekend. Back when I swapped the diff's I didn't have another set of poly bushings, so using the old racers trick I filled the rubber with urathane. It helps but the real deal is better. Got around to putting that together finally.
Since I dropped my subframe down and put new alignment bolts in, My modified ctrl arms to correct that negative camber now went the other direction. So I put the stockers back in. (Red ones)
Flat facing surfaces right behind a tire... that didn't go over super well with my paint. So a quick toughening up job was applied too. We shall see how this hold up.
And then a couple low quality pictures from the other night as we were leaving church.
Since I dropped my subframe down and put new alignment bolts in, My modified ctrl arms to correct that negative camber now went the other direction. So I put the stockers back in. (Red ones)
Flat facing surfaces right behind a tire... that didn't go over super well with my paint. So a quick toughening up job was applied too. We shall see how this hold up.
And then a couple low quality pictures from the other night as we were leaving church.
Last edited by Eppic; 04-01-2018 at 12:53 PM.
#207
Junior Member
Thread Starter
Join Date: Nov 2016
Location: Steinbach, Manitoba
Posts: 116
Total Cats: 52
Went for a boot in the back yard this weekend. The snow is starting to melt. I was itching to get muddy. Big wall of ice under the surface that I couldn't get over before the ecu got wet and dropped two cylinders.
All that water and the engine still looks awesome.
However going deep without being prepared causes issues.
Left it over night. Water froze. Had me an unhappy ecu this morning with all that ice. Good thing I got spares. This one has gone into a bag of rice.
In the process of determining my running issues, I remembered that I put the wrong fuel rail spacers in. I couldn't find the right ones at the time. So... thanks to my 3d printer, 18 minutes later I had the correct spacers.
All that water and the engine still looks awesome.
However going deep without being prepared causes issues.
Left it over night. Water froze. Had me an unhappy ecu this morning with all that ice. Good thing I got spares. This one has gone into a bag of rice.
In the process of determining my running issues, I remembered that I put the wrong fuel rail spacers in. I couldn't find the right ones at the time. So... thanks to my 3d printer, 18 minutes later I had the correct spacers.
Thread
Thread Starter
Forum
Replies
Last Post