Dead Map sensor?
#1
Senior Member
Thread Starter
iTrader: (19)
Join Date: Oct 2007
Location: MoCo, MD
Posts: 703
Total Cats: 0
Dead Map sensor?
I picked up an ECU from Serper3. He was having MAP sensor problems, I'm having them as well.
In the Gauges view I get "-" as manifold pressure. The sensor is getting +5v, has a good ground, but will not vary the signal voltage. Hooking the signal wire for the Adaptronic to my AVC-R's map sensor I get a reading of 276kpa.
This is a dead map sensor, correct? I just want to make sure I'm not overlooking something obvious as I'm new to Adaptronic.
If the sensor's dead, will this one work?
GM 3 Bar MAP Sensor DIYAutoTune.com
Thanks
Sorry for the misspelled thread title. Removing 250ft of cemented in chain link fence doesn't do wonders for finger dexterity the next day.
In the Gauges view I get "-" as manifold pressure. The sensor is getting +5v, has a good ground, but will not vary the signal voltage. Hooking the signal wire for the Adaptronic to my AVC-R's map sensor I get a reading of 276kpa.
This is a dead map sensor, correct? I just want to make sure I'm not overlooking something obvious as I'm new to Adaptronic.
If the sensor's dead, will this one work?
GM 3 Bar MAP Sensor DIYAutoTune.com
Thanks
Sorry for the misspelled thread title. Removing 250ft of cemented in chain link fence doesn't do wonders for finger dexterity the next day.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM